V33h tube guitar amplifier with reverb, The rear panel – Crate V33H User Manual

Page 5

V33H Tube Guitar Amplifier with Reverb

The Rear Panel

15. AC LINE CORD: The grounded power

cord should only be plugged into a
grounded power outlet that meets
all applicable electrical codes, and is
compatible with the voltage, power,
and frequency requirements stated on
the V33H rear panel. Do not attempt to
defeat the safety ground connection.

16. Voltage Select Switch: Set this switch

to “115” for 120 VAC mains, and to
“230” for 220-240 VAC mains.

With the amplifier power cord
unplugged, use the tip of a small flat-
blade screwdriver to slide this switch to
the proper position.

17. FOOTSWITCH Jack: Use this 1/4"

TRS jack to connect the cable of the
optional VSFS-2 footswitch. This allows
for remote control of channel switch-
ing and the boost effect (Tip= channel
select, Ring = boost on/off).

18. EFFECT SEND: Use this 1/4" TS jack

to send the signal to an external effects
box.

Note: The Effect Send jack can be
used as a line-level output from the pre-
amplifier stage of the V33H to a mixer
or recorder. The signal comes after the
EQ stage but before the reverb stage.

19. EFFECT RETURN: Use this 1/4" TS

jack to return the signal from an exter-
nal effects box.

Note: The Effect Return jack discon-
nects the signal from the preamplifier
stage of the V33H, so only the signal at
the Effect Return jack is sent on to the
power amplifier.

20. EXTENSION SPEAKER: Use this 1/4"

TS jack to connect the amplifier to an
8 ohm extension speaker.

21. SPEAKER 8 OHMS: Use this 1/4" TS

jack to connect the amplifier to an 8 ohm
speaker like the Crate V212B.

c 2007 LOUD TECHNOLOGIES INC

DESIGNED IN ST.LOUIS MO, USA. MANUFACTURED IN CHINA, FABRIQUE EN CHINE

This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.

3031613

CONFORMS TO

IEC 60065

~100-240V

50-60 Hz 120W

N222

SERIAL NUMBER

MANUFACTURING DATE

AVIS: RISQUE DE CHOC ELECTRIQUE — NE PAS OUVRIR

WARNING:

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT

EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. DO NOT REMOVE COVER. NO
USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL.

FOOTSWITCH

EFFECT

SEND

EFFECT

RETURN

EXTENSION

SPEAKER

8 Ohms

115