Crate FW120H - Manual (Page 6)

FlexWave120H Guitar Amplifier w/DSP and Channel Tracking
6
BANK A
BANK B 4 OHM
MIN LOAD
CLEAN / OD
HIGH GAIN
100 VAC: 250V T4A
120 VAC: 250V T3A
230/240 VAC: 250V T1.6A
EXT SPKR DSP INSERT CHANNEL
FOOTSWITCH
26 25 27 28 29 30
21. SHAPE: Use this control to “dial in”
the tone for the High Gain channel. Rotating
this control counter-clockwise enhances the
mid frequencies, while rotating it clockwise
enhances the low and high frequencies.
22. GAIN: Use this control to adjust the
amount of distortion for the High Gain channel.
23. HIGH GAIN LED: This LED illuminates
when the High Gain channel is selected.
24. INPUT: Use this jack to connect your
guitar to the amplifier by means of a shield-
ed instrument cable.
HIGH GAIN
OVERDRIVE
LEVEL SHAPE GAIN
INPUT
HIGH GAIN
0 0 10 10 0 0 10 10 0 0 10 10
18 19 20 21 22 24 23
The Rear Panel
25. INSERT: Use this jack to connect an
external signal processor to the amplifier. Use
Crate’s STP201, STP202, or STP203 stereo-
to-mono Y-cord or an adapter such as Crate’s
YPP117 and two 1/4" mono signal cables to
connect to the effect, as shown below.
26. CHANNEL FOOTSWITCH: Use this jack
to connect one of the footswitch cables to the
three-button footswitch (supplied). This allows
you to remotely switch between the Clean,
High Gain, and Overdrive
channels. Additional infor-
mation about the opera-
tion of the footswitch is
on page 8.
27. DSP FOOTSWITCH:
Use this jack to connect
one of the footswitch
cables to the three-but-
ton footswitch (supplied).
This allows you to select
between two DSP pre-
sets for each of the three
channels. Additional infor-
mation about the opera-
tion of the footswitch is
on page 8. 28. EXTENSION SPEAKER: Use this jack
to connect the amplifier to an external
speaker cabinet.
Note: The external speaker cabinet should
have a nominal impedance of 4 ohms or higher.
29. FUSE: The fuse protects the amplifier
from damage caused by a faulty AC power
source or other problems. If the fuse opens,
replace it with the same size and type. If
fuses continue to fail, check the AC source.
If the source is okay,
refer to page 12 or con-
tact your Crate dealer
for service information.
30. POWER CORD:
This grounded power
cord is to be plugged
into a grounded power
outlet, wired to current
electrical codes and
compatible with the
voltage, power, and
frequency requirements
stated on the rear panel.
Do not attempt to defeat
the safety ground con-
nection!
TIP
RING
SLEEVE RETURN
SEND
GROUND
Stereo-to-mono Y-cord:
to Insert
jack
to Insert
jack
(STP201, 3'
STP202, 6'
STP203, 9')
(YPP117)
(1/4"-TO-1/4"
MONO SHIELDED
CABLES)
to
effect
"OUT"
jack
to
effect
"IN"
jack
External Effect
TIP
RING
SLEEVE
Y-adapter and 2 cables:
External Effect
RING
RING
TIP
TIP
to
effect
"OUT"
jack
to
effect
"IN"
jack