Connecting to your computer – DXG Technology DXG-202V User Manual

Page 29

You will need to connect the Digital Video Camera to your computer's USB port to

transfer photos into your computer. This section shows how you can connect the
Digital Video Camera to your computer.

First, you must install the Digital Video Camera Driver from the software CD-ROM

before connecting to ensure your computer functions properly with USB. See the
section "Installing Software" for details on how to install the driver.

Using the Digital Video Camera as a Web camera or as a Mass

Storage Drive

When you connect the Digital Video Camera to your computer, you can use it as
a Web camera or as a Mass Storage drive. You can then join in video conferencing

sessions on the Internet. You need to install the Digital Video Camera Driver and
required application softwares from the software CD-ROM before you can start

using it as a Web camera. See the section "Installing Software" for installation
instructions.

Using the Digital Video Camera as a Web camera lets you capture video directly

into your computer for later editing or enhancing your videos. See the section
"Installing Software" for installation instructions.

●

Step 1. Make sure the Digital Video Camera has two ”AA”

batteries in the compartment.

●

Step 2. Connect the smaller end of the USB

cable into the USB port of your Digital

Digital Video Camera.

Note: Make sure to gently plug the USB cable in the right direction to avoid

possible damage to USB connector.

●

Step 3 Connect the other end

of the USB cable to the

USB port located on the
back of your computer.

The Digital Video Camera’s LCD

Panel will turn on and enter

PC Connection Menu.

Connecting to Your Computer