Comtech EF Data UB-54 - Manual (Page 16)

Installation UB-54 Breakout Panel
2–2 Rev. 1
2.2 Installation
The breakout panel arrives fully assembled from the factory. Install the breakout panel as
follows:
1. Position the breakout panel in the rack.
2. Secure the breakout panel to the rack using 10-32 screws.
3. Connect the cables to the front and/or rear panel (refer to Figure 2-1). Refer to
Section 2.3 for connector pinout, placement, and function.
TRIB 1 DATA TRIB 2 DATA TRIB 3 DATA TRIB 4 DATA TRIB 5 DATA TRIB 6 DATA TRIB 7 DATA TRIB 8 DATA AUX
J9 J8 J7 J4 J1 J2 J3 J5 J6
MUX / DEMUX
BREAKOUT
UB-54
RX AGGREGATE DEMUX T1-4 DEMUX T5-8
J12 J13 J11 J10
MUX DATA
Figure 2-1. UB-54 Front and Rear Views
Note: One UB-54 breakout panel can be used with a multiplexer or a demultiplexer,
but not both at the same time.
4. (Used with a Multiplexer only) Connect breakout panel to the SDM-300 Satellite
Modem using a 100-pin ribbon cable conforming to Table 2-12, (Comtech
EFData Part No. CA/90101G100-3 or equivalent) as shown in Figure 2-2.