Code Blue 360-DEGREE PEDESTAL MOUNT PUBLIC ADDRESS SPEAKER - Manual (Page 12)

Administrator Guide
Code Blue ● ● ● ● ●

Ladder
– to reach the top of the unit.

Security bit - to secure the PAS top to the adapter ring.

3/8
” socket set - to secure the PAS adapter base to the top of the unit.

6mm Allen wrench - to secure the PAS adapter ring to the top of the PAS adapter
base.
Remove 120V AC power from the unit. 3.2.2.1
3.2.3
Remove existing beacon/strobe assembly. Disconnect the red/black and 3.2.3.1
yellow/yellow wiring harnesses connected to the beacon/strobe mounted on top of
the CB 5-s unit.
Place a foam gasket on the unit, then the adapter base on top of the 3.2.3.2
bollard and tighten the 3/8
” bolts with washers to secure the adapter base to the set
screws to hold in place.
Place adapter ring on top of the adapter base and tighten the three Allen 3.2.3.3
set screws to hold in place (see
Figure 2 on Page 12).

Connect the red/black and yellow/yellow wiring harnesses to the red/black 3.2.4.1
and yellow/yellow wiring pigtails coming from the beacon/strobe.
Connect the 6 pin wiring harness, 7 pin control cable and RJ-11 audio 3.2.4.2
cable to the ports on the amplifier.
Set the PAS speaker unit on the adapter ring, lining up the screw holes at 3.2.4.3
the bottom of the unit. Secure the speaker unit with the provided security screws.
Reapply power to the unit (See Error! Reference source not found. on 3.2.4.4
age 21).