Code CR6000 - Manual (Page 6)

6
D019548_02_CR6000_User_Manual
4.0 - Using a CR6000
Out of a Stand
5.0 - Using a CR6000
In a Stand
25 mm
90°
25 mm
° 90
7.0 - Reading Modes and Barcode Types
Reading Mode Barcode Types
Auto (Default) Reads dot peen and laser-etched marks by automatically adjusting the illumination for optimal
reading of a variety of DPM barcodes.
Dark Field Options:
1. Reads dot peen marks at a 15-45 angle, or
2. Reads laser-etched marks at a 90 angle, or
3. Reads dot peen marks at a 15-45 angle, and laser-etched marks at a 90 angle.
Diffuse Bright Options:
1. Reads dot peen marks at a 90 angle, or
2. Reads laser-etched marks at a 90 angle, or
3. Reads both dot peen and laser-etched marks at a 90 angle.
Direct Bright Reads barcodes printed on paper.
Curved Surface Reads dot peen and laser-etched marks printed on curved surfaces at a 90 angle.
6.0 - Optimizing DPM Reading
The CR6000 reader defaults to Auto Mode. The Reading Mode automatically adjusts to optimize performance on various DPM barcodes. If your
application involves only one type of DPM barcode, the CR6000 can be further enhanced by enabling the specific Reading Mode that works best
for your barcode. To optimize DPM reading, please refer to the CR6000 Configuration Guide located at www.codecorp.com/files.php.
°
°
° °
°
°
°
°
Barcode reading performance will vary depending on mark and surface type. Refer to the CR6000 Configuration Guide located. To change
Reading Modes, please refer to the CR6000 Configuration Guide located at www.codecorp.com/files.php.