Coda Audio C25 - Manual (Page 4)

4 C25 User Guide Version 1.0
Important Safety Instructions
1)
Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not block any ventilation openings and install in accordance with the manufacturer’s
instructions.
6) Unplug this apparatus during lightning storms or when unused for long periods of time.
7) Clean only with a dry cloth.
8) Do not use this apparatus near water; the apparatus shall not be exposed to dripping or
splashing and no objects filled with liquids, such as vases shall be placed on the apparatus.
9) Refer all servicing to qualified service personnel. Servicing is required when the apparatus
has been damaged in any way, such as if the power-supply cord or plug is damaged, liquid
has been spilled or objects have fallen into the apparatus, the apparatus has been exposed
to rain or moisture, does not operate normally, or has been dropped.
Installation
Electrical
This amplifier has been manufactured to comply with your local power supply requirements but,
before connecting the unit to the supply, ensure that the voltage (printed on the rear panel) is correct.
Make sure power outlets conform to the power requirements listed on the back of the unit. Damage
caused by connecting to improper AC voltage is not covered by the warranty.
Safety Warning
Where a mains plug or appliance coupler is used as the disconnect device, it should remain readily
operable.
Where the amplifier is mounted in a rack and permanently connected to the mains, then the rack
should be installed with a readily accessible connector or an all pole circuit breaker.
This unit is fitted with a 3-wire power cord. For safety reasons the earth lead should not be
disconnected in any circumstance. If ground loops are encountered, consult the section on ‘Input
Connections’ later in this manual.
The wiring colours are:
230 V Areas: Earth = Green and Yellow
120 V Areas: Earth: = Green
Neutral: = Blue Neutral: = White
Live: = Brown Live: = Black
Warning: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or
moisture.