Coda Audio C25 - Manual (Page 10)

10 C25 User Guide Version 1.0
Technical Specification
Output power (Watts RMS)
per channel
8 Ohm @ 1 kHz 650
4 Ohm @ 1 kHz 1250
2 Ohm @ 1 kHz 2200
Mono Bridged
8 Ohm @ 1 kHz 2500
4 Ohm @ 1 kHz 4400
THD @ rated power
4 Ohm 1 kHz <0.008 %
20 Hz-20 kHz <0.03 %
Input CMRR
>90 dB
Hum & Noise
-105 dB
Gain (selectable)
+32 dB/+26 dB/+33 dB
Sensitivity for rated output (4 Ohm)
+7 dBu/+13 dBu/+6 dBu (1.5V)
Damping Factor 1 kHz, 8 ohms >400
Frequency response
20 Hz-2 0kHz +0/-0.5 dB
Input impedance
(actively balanced)
20 kOhm
Dimensions (mm) - 2U
88 x 482 x 428
Weight 10kgs
Power requirement
230 VAC @ 12amps max
115 VAC @ 18 amps max
Power requirements
The C25 can be supplied for nominal mains voltage of 115 V or 230 V.
An internal link can be set to either 100 V or 120 V for the 115 V version and 220 V or 24 0V for the
230 V version. Normally these are set to 120 V and 240 V respectively.
This amplifier will only operate to its very high specification if it is installed and operated as
described in this manual.