Cloud Electronics 46-120 - CXL-46T - Manual (Page 2)

CXL-46T Installation Instructions v1.0 2
INTRODUCTION
The CXL-46T is an optional transformer for the 46-120 and 46-120 MEDIA Multi-Zone Mixer Amplifiers, to permit the Mixer
Amplifiers to directly drive 100 V-line or 70 V-line loudspeaker systems. The transformer is rated at 120 W output, and is mounted
internally. Up to four CXL-46Ts (one per output channel) may be fitted to a 46-120 or 46-120
MEDIA . The outputs are available on
the 8-pin 5 mm-pitch screw-terminal SPEAKER OUTPUTS connector on the host unit’s rear panel.
Speaker Outputs
NOTE: unlike other Cloud multi-channel amplifiers, all 46-120 models use a single output connector for both low impedance and
70/100 V-line operation. Thus it is NOT possible for any channel of a 46-120 to drive both low impedance speakers and
70/100 V-line systems simultaneously. The check boxes below the connector should be used to indicate the standard each output is
set for.
FITTING THE CXL-46T TRANSFORMER
The CXL-46T transformer is a toroidal type, and is supplied pre-terminated with 2-pin and 3-pin connectors as shown:
RED
BLACK
PRIMARY
WINDING
CONNECTOR
(male)
SECONDARY
WINDING
CONNECTOR
(female)
WHITE
BLUE
MAUVE
46-120 / 46-120 MEDIA Rear Panel