CHIAYO SDR-1216 - Manual (Page 3)

9
Audio output connection
There are two audio outputs on the back of the Diversity SDR receivers. Mic-
level balanced and Line-level unbalanced. Use shielded audio cable for the
connection between the receiver and the mixer. If the mixer / amp is a 1/4" phone
jack, connect a cable from the 1/4" unbalanced audio output from the receiver to
the mixer / amp. If the mixer has an XLR input, connect a cable from the
balanced XLR audio output from the receiver to the mixer input. Audio output
connection is as Fig.2.
For best operation, the receiver should be at
least 1m above the ground and at least 1m
away from a wall or metal surface to minimize
reflection. The transmitter should also be at
least 1m away from a wall or metal surface to
minimize reflection. The transmitter should also
be at least 1m away from the receiver, as
shown in Fig. 1.
Keep antennas away from noise source such as
motors, automobiles, neon light as well as large
metal objects.
1.GND
2.
3. + - 3 1 2
Fig.1
Fig.2
UHF Beltpack transmitter SM-5016
Parts and functions
Battery Installation
Antenna
Battery weak indicator
Audio mute switch
Mini-XLR connector
Power ON / OFF switch
LCD display
Charging port
Cover release button
Charging contacts
Lavalier microphone
Mic clip
12
13 14
16 15
14
13
12 SET
UP
DOWN
GT
MT
15
16
9
GAIN setting (GT/MT)
Gain control is an adjustable design that enables user to set different output levels. GT is for
the use of instrument with high impedance, such as guitar while MT is for the use of low
impedance such as lavalier or headset microphone.