CHIAYO SDR-1216 - Manual (Page 2)

Introduction
As this is a shared operating manual of , we
suggest you to read this operation manual thoroughly to be familiarized with each part
of function before using.
Congratulation in owning one of these state-of-the-art PLL Synthesized 16-channel
frequency-agile VHF / UHF high band ( SDR-1216 / 2216 / 1816SC / 2816SC )
professional wireless receivers. According to their frequency range, these receivers are
designed to be matched with Chiayo VHF/UHF high band PLL Synthesized transmitters
(handheld or beltpack).
The standard combinations are as follow:
SDR-receiver and SQ or SM-transmitter
SDR-1216 / 2216 / 1816SC / 2816SC
1.GND
2.
3. + - 3 1 2
10
Parts and functions of SDR-series receivers
Making changes to various settings in SM-5016
3.Input Level Gain Control Adjustment
Low impedance (Lo-Z) " MT" & high impedance (Hi-Z) " GT" gain controls are
situated inside the transmitter. Gain controls are adjustment ports that enable you to
use microphones of differing output levels and Guitar or instruments with Hi-Z
output. To adjust microphone (Lo-Z) input levels, turn the "MT" control and to adjust
the Guitar or instrument (Hi-Z) input, adjust the "GT" gain control to set the
transmitter's desired audio input level.
1.Making changes to CHANNEL / FREQUENCY:
Use UP or DOWN button to go to the CHANNEL /FREQUENCY page.
The cursor will flash to allow changes to be made. Pressing UP or DOWN button
will increase or decrease the channel number. The corresponding frequency will
change accordingly. When a desired channel(frequency) is being selected, it will
be automatically saved and stored in the memory.
Remark : When changing transmitter frequencies, user should take care
not to cause interference to other channels / users.
2.Making changes to Battery selection:
Use UP or DOWN button to go to the Battery selection page.
Press SET for about 2 seconds to activate the cursor. Press UP or DOWN button to
move the cursor to either NiMH ( rechargeable battery ) or AKLN ( Alkaline battery )
position.
When the desired option has been selected, press SET for about 2 seconds to save
and store the data in the memory.
Remark : "NiMH" must be selected when rechargeable battery is being
used. Never select "AKLN" ( Alkaline ) when transmitter is intended for
charging as Alkaline battery can not be charged ! Wrong selection of
battery will cause battery sensing electronics to display wrong information
and mislead charging status.