CHIAYO SDR-5216 - Manual (Page 3)

9
1. Audio output connection
There are two audio outputs on the back of the Diversity SDR receivers. Mic-level
balanced and Line-level unbalanced. Use shielded audio cable for the connection
between the receiver and the mixer. If the mixer / amp is a 1/4" phone jack, connect
a cable from the 1/4" unbalanced audio output from the receiver to the mixer / amp.
If the mixer has an XLR input, connect a cable from the balanced XLR audio output
from the receiver to the mixer input. Audio output connection is as Fig.2.
Fig.2
Parts and functions of SDR-5116/5216 receivers
1. Power switch
2. Diversity indicator
3. RF signal indicator
4. Audio signal indicator
5. Channel LED
6. Channel switch
7. Volume control
8. Antenna B socket (TNC)
9. Balanced audio output
10. Unbalanced audio output
11. Squelch control
12. DC in
13. Antenna A socket (TNC)
3.Input Level Gain Control Adjustment
Low impedance (Lo-Z) " MT" & high impedance (Hi-Z) " GT" gain controls are
situated inside the transmitter. Gain controls are adjustment ports that enable you to
use microphones of differing output levels and Guitar or instruments with Hi-Z
output. To adjust microphone (Lo-Z) input levels, turn the "MT" control and to adjust
the Guitar or instrument (Hi-Z) input, adjust the "GT" gain control to set the
transmitter's desired audio input level.
Making changes to various settings in SM-5016
1.Making changes to CHANNEL / FREQUENCY:
Use UP or DOWN button to go to the CHANNEL /FREQUENCY page.
The cursor will flash to allow changes to be made. Pressing UP or DOWN button
will increase or decrease the channel number. The corresponding frequency will
change accordingly. When a desired channel(frequency) is being selected, it will
be automatically saved and stored in the memory.
Remark : When changing transmitter frequencies, user should take care
not to cause interference to other channels / users.
2.Making changes to Battery selection:
Use UP or DOWN button to go to the Battery selection page.
Press SET for about 2 seconds to activate the cursor. Press UP or DOWN button to
move the cursor to either NiMH ( rechargeable battery ) or AKLN ( Alkaline battery )
position.
When the desired option has been selected, press SET for about 2 seconds to save
and store the data in the memory.
Remark : "NiMH" must be selected when rechargeable battery is being
used. Never select "AKLN" ( Alkaline ) when transmitter is intended for
charging as Alkaline battery can not be charged ! Wrong selection of
battery will cause battery sensing electronics to display wrong information
and mislead charging status.