Dimplex WFC 3NB - Manual

350mm min
120mm
350mm
575mm
Installation and Operating Instructions
Dimplex Wall-mounted Fan Convector
08/18724/2 Issue 2
Models : WFC 3NB and WFC 3NS
Dimensions
Model(s) Specification
WFC 3NB
3kW, Switch, Thermostat & Neon - Black
WFC 3NS
3kW, Switch, Thermostat & Neon - Silver
Fig. 1
Installation
Before undertaking installation work, ensure the electricity
supply is disconnected from any relevant fixed wiring
.
Supply cable is not provided with this appliance, and a
competent electrician should therefore install it.
The appliance must be fitted horizontally with the cable or
conduit entry at bottom right. It should be mounted such that the
underside is at least 350mm above the floor and the top of the
heater is 150mm below any overhanging shelf or obstruction.
This heater must be used on an A.C.~ supply only and the
voltage marked on the heater must correspond to the
supply voltage.
To comply with the I.E.E. Wiring Regulations, the appliance
must be earthed; the supply circuit must be adequate for the
input of the appliance, and the circuit protected by a suitable
13A fuse. A suitable termination to the fixed wiring of the
premises must be provided adjacent to the final position of the
appliance. In this instance, such a termination can be a double-
pole switch with a contact separation of at least 3mm in all
poles.
The heater must not be located immediately below a fixed
socket-outlet
.
Electrical
WARNING : THIS APPLIANCE MUST BE EARTHED.
After ensuring the electricity supply is not live, electrical
connections can be made, either to an adjacent double-pole
switch having a contact separation of at least 3mm in all poles
or to a plug-top for use in a standard 13A socket.
If the latter: Connect Green and Yellow wire to
marked E or
plug terminal
Green or Green and Yellow. Connect Blue
wire to plug terminal marked N or Black. Connect Brown wire
to plug terminal marked L or Red.
Refit cover, first hooking top over the back of the unit and then
securing the bottom by refitting the two screws under the
bottom edge. The appliance is now ready for use and the
electricity supply can be reinstated.
THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
. THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
.
IMPORTANT SAFETY ADVICE
WARNING – THIS APPLIANCE MUST NOT BE USED IN
A BATHROOM.
WARNING – DO NOT USE THIS HEATER IN THE
IMMEDIATE SURROUNDINGS OF A BATH, A SHOWER
OR A SWIMMING POOL.
WARNING – THIS HEATER MUST NOT BE LOCATED
IMMEDIATELY BELOW A FIXED SOCKET OUTLET.
DO NOT USE THE HEATER UNTIL IT IS WALL
MOUNTED CORRECTLY.
The heater carries a warning 'Do Not Cover' to alert
the user to the risk of overheating that exists if the
heater is accidentally covered.
NEVER cover or obstruct in any way the air inlet slots
at the front of the heater or the heat outlet slots in the
base of the heater.
Keep combustible materials such as drapes and other
furnishings clear from the front of the heater. Do not
use heater to dry your laundry.
This appliance is not intended for use by children or
other persons without assistance or supervision if
their physical, sensory or mental capabilities prevent
them from using it safely. Children should be
supervised to ensure that they do not play with the
appliance.
If young children, the aged, or infirm are likely to be
left in the vicinity of the heater, we advise that
adequate precautions should be taken. We
recommend that a guard be fitted to ensure contact
with the heater is avoided and objects cannot be
inserted into the product.
WARNING: In order to avoid a hazard due to
inadvertent resetting of the thermal cut-out, this
appliance must not be supplied through an external
switching device, such as a timer, or connected to a
circuit that is regularly switched on and off by the
utility.Do not use where excessive dust or moisture is
present.
For further information, please contact our guard
supplier direct on Tel. No. 01603 667957, or in the
case of difficulty or for further advice contact the
Customer Helpline.