Directed Electronics 50.7X - Manual (Page 25)

25 © 2008 Directed Electronics. All rights reserved.
sponse will reset.
➢
System override
To disarm the system without a remote control:
You will need to use your Override Switch located on your systems
control center (see diagram below) to disarm the system. The Override
Switch disarms the system only if you have the vehicle key.
2. Radious will be if not specified.
1. Texture is same as
3. Body color : INJECT TOLERANCE SPEC.
*Tolerance please refer specification
of tolerance limits "c"
120~300
DIMENSION
30~120
UNDER 6
0.40 0.80
0.20
0.10
0.08
A
± GRADE
6~30
B
±
0.40
0.20
0.16
2.00
C
±
0.40
0.80
0.30
DEI
NUTEK
FELIX
VICTOR
APPD BY
UNIT:
M/M
CODE
MATERIAL
FINISH
SCALE:
1:1
YGF
SHEET
DRN BY
CHK BY
11/20/07
OF
DATE
A4
TITLE
DEPT SIZE
REV.
1
REVISIONS
DESCRIPTION
CORPORATION
OLED IVU
94I0600
DRAWING NO
0
REV
DATE DRN.
94I0600
CASE P/N:IADGH0A1
KEY P/N:IKDEL0A0
36.32
11.50
10.44
%2'<0$7(5,$/+,+($7$%689
%/$&.
To check proper operation:
Open the door. The alarm will sound. •
Immediately insert the key into the ignition and turn it to the RUN or ON
position. (all the indicators in the dash will turn on).
Press the Override Switch once, the alarm should shut off and now the
vehicle should start with the key.
Note: The Override Switch feature allows you to select a specific
number of presses needed to disarm the alarm. If the Override
Switch has been programmed to a new number of presses by your
authorized dealer, that number should be indicated below.
Override Switch Number ___________