Denon DVD-758 - Manual (Page 11)

EN
English
FUNCTIONAL OVERVIEW
Loading the Batteries
Using a Remote Control
Displays during Operation
1. Open the battery compartment cover.
2. Insert two “AA” (R6P) batteries, with each
one oriented correctly.
3. Close the cover.
Power on
Tray open
Tray closed
Loading the Disc
HDMI output mode
(480p/576p) is selected
(576p is displayed after
480p)
HDMI output mode (720p) is
selected
HDMI output mode (1080i) is
selected
HDMI output mode (1080p)
is selected
HDMI output mode (OFF) is
selected
Program playback is set
Program playback setting
group (folder) is selected
Program playback setting
ALL CLEAR is selected
Random playback is set
Power off
No disc inserted or cannot
read
All group playback setting
Super Audio CD setup
(2CH AREA) selected
Super Audio CD setup
(MULTI-CH AREA) selected
Cautions On Batteries
• Use “AA” (R6P) batteries in this remote control unit.
• Replace the batteries with new ones approximately once
a year, though this depends on the frequency with which
the remote control unit is used.
• If the remote control unit does not operate within a close
proximity of the main unit, replace the batteries with new
ones, even if less than a year has passed.
• The included batteries serve only for verifying operation.
Replace them with new batteries as soon as possible.
• When inserting the batteries, be careful to do so in the
proper direction, following the and marks in the
remote control unit’s battery
compartment.
• To prevent damage or battery fluid leakage:
• Do not mix a new battery with an old one.
• Do not mix two different types of batteries such as
alkaline and manganese.
• Do not short-circuit, disassemble, heat or dispose of
batteries in flames.
• Remove the batteries when not planning to use the
remote control unit for a long period of time.
• If the batteries should leak, carefully wipe off the fluid
from the inside of the battery compartment, then insert
new batteries.
NOTES:
• The front panel display has blinked while setting the
program playback.
• “P**- ●●●” is displayed in the front panel display while
setting the program playback. (“**” is program number,
“
●●●” is track number.)
• “A” is displayed in front panel display while selecting the
audio file (CD, MP3, WMA, DVD-Audio).
• “F-***” is displayed in the front panel display while selecting
the group (folder). (“***” is group (folder) number.)
• “A-CLEAr” is displayed in the front panel display while
selecting ALL CLEAR.
• “SHUFFLE” is displayed in the front panel display while
setting the random playback.
• “A-PLAY” is displayed on the front panel display while
setting the all group playback.
Keep in mind the following when using the remote control:
• Make sure that there are no obstacles between the remote
control and the remote sensor on the unit.
• Remote operation may become unreliable if strong sunlight or
fluorescent light is shining on the remote sensor of the unit.
• Remote control for different devices can interfere with each
other. Avoid using remote control for other equipment locat-
ed close to the unit.
• Replace the batteries when you notice a fall off in the oper-
ating range of the remote control.
• The maximum operable ranges from the unit are as follows.
- Line of sight:
approx. 23 feet (7m)
- Either side of the center: approx. 16 feet (5m) within 30˚
- Above:
approx. 16 feet (5m) within 15˚
- Below: approx. 10 feet (3m) within 30˚
16 feet (5m)
30 °
23 feet (7m) 16 feet (5m)
30 °
– 11 –
E6EG0UD(EN).qx4 07.12.21 3:24 PM Page 11