Dynex DX-CRCF12 - Manual (Page 11)

Troubleshooting
11
Formatting a memory card
If your computer has trouble recognizing a new memory card,
format the memory card in your camera or by using the
following steps:
1 Insert your memory card into the reader.
2 Click Start, then click My Computer.
3 Under Removable Storage, right-click the appropriate
memory card icon.
4 Click Format.
5 Type in a name into the Volume Label box. The name of
your memory card appears next to the icon.
6 Click Start.
7 When you see a warning, click OK.
8 Click OK on the Format Complete window.
9 Click Close to finish.
Troubleshooting
If memory cards do not appear in My Computer or Windows Explorer,
check the following:
• Make sure that the card reader is fully connected into your
computer. Unplug and reconnect your card reader.
• Try a different memory card of the same type in the same
slot. If a different memory card works, the original memory
card should be replaced.
• Disconnect the cable from your card reader and shine a
flashlight into the empty card slots. Look to see if any pins
inside are bent, and straighten bent pins with the tip of a
mechanical pencil. Replace your memory card reader if a
pin has bent so much that it touches another pin.
DX-CRCF12_07-261 - combined.fm Page 11 Monday, July 2, 2007 3:51 PM