Caple C871i - Manual (Page 11)

2 2 / USING YOUR APPLIANCE EN
OFFSET PROGRAMMING
This allows you to adjust the finishing time
and the duration of this cooking session.
1. Switch on the hob of your choice, using the
button.
2. Press the button and it will display the
current time.If the time is correct, go to point
4, and if not, adjust the time.
3. ADJUSTING THE CURRENT TIME : Use
the “-”and “+”power level buttons in zone (B)
to change the hour and use the “-”and
“+”timer buttons (G) to adjust the minutes.
4. Validate the time by pressing the button
(the digits will then flash).
5. Adjust the time to when you wish cooking
to finish with the “ -”and“+” buttons from
zones (B) and (E).
6. Validate by pressing the button.
7. Adjust the cooking time using the “-”and
“+”timer buttons in zone (G).
8. Validate by pressing the button.
9. Define the chosen power level for cooking
with the“-”and “+”power level buttons from
zone (B).
10. Validate the power by pressing the but-
ton.
11. Once programmed, it displays (Auto) and
then the digits go off and only a red dot
remains lit.
IMPORTANT : Offset programming cannot be
used at the same time on more than one hob.
2. Once the hob has heated up, select the
chosen power level by pressing the “-”button
in zone “B”. The “BOOSTER” function will be
cancelled by pressing any other power sen-
sor associated with the hob, or with the
on/off sensor.
11
ADJUSTING THE TIMER
There is a timer for each cooking zone.
Use the “
” button to select the cooking
zone on which you would like to use the timer.
If you press this button several times, a rotat-
ing symbol will show which cooking zone the
timer is being used for.
The timer may only be used for one cooking
zone at a time.
To use the timer:
- turn on the cooking zone
- select the rotating symbol for this cooking
zone.
The timer only operates if there is something
on the cooking zone.
- adjust the timing by pressing “
+
“(or “-”
adjusting from 99,98,97,...min).
As soon as you release the button, the power
display will show the power of the cooking
zone or a
“ t ”.
When you have finished cooking, the cooking
zone turns itself off, the timer shows 0
0 and a
b biip p sounds. Press any button to stop the bip.
- To change the timer settings, press the - or +
.
- To stop the timer, press the “ ” button.
- To use the timer on a different cooking zone,
choose a new use by pressing the “
” but-
ton several times.
When the previous timing stops, set your tim-
ing for the new cooking zone using the "+" or
"-" buttons.
• •