Caple C871i - Manual (Page 10)

EN 2 2 / USING YOUR APPLIANCE
• •
DESCRIPTION OF THE CONTROL
PANEL • •
Start/stop touch control.
Power level - + touch controls.
Memory function touch control.
Interrupt function touch control.
Booster max power touch control.
Offset programming touch control.
Timer touch controls.
A
B
C
Tip
For simultaneous use, favour the use
of cooking zones located on opposite
sides of the hob.
On the same side, the use of a cooking
zone at maximum power results in an auto-
matic limitation of the other cooking zone
on that side, which is indicated in the power
level display.
C A B
• •
G D F E
MEMORY FUNCTION
Allows you to access a determined power
level at any moment. Press the button
and
the hob will heat up to a determined power
level (The power level defined by the manu-
facturer is 8), but the user can change the
value of this power level by following these
steps.
Modification of the memory function power
(With the hob switched off)
1. Keep the button
pressed down until a
beep sounds.
2. The power level which has been defined
will flash on the display.
3. Modify the power level with the “-”and
“+”power level buttons (B).
4. Press the button
again to validate the
operation.
5. Switch off the hob.
INTERRUPT FUNCTION
This allows you to always be able to trip the
power for a certain time. This gives the user
total flexibility.
1. Start with the hob switched on and a deter-
mined power level.
2. Press the button
and then you can
enter the new power level and the time which
it is going to be active. The power level is
adjusted with the “-”and “+”buttons in zone (B)
and the duration is adjusted using the “-”and
“+”buttons in zone (G).
3. Then validate by pressing the button
.
4. The new power level is displayed with a dot.
5. Once the time has passed, return to the ini-
tial position and the dot will disappear.
MAX POWER BOOSTER
The cooking areas are equipped with a
“BOOSTER” function. This function means
that the maximum temperature can be obtai-
ned quickly.
1.Press the power level button. The hob
power display will display (bo) and the hob
will start to give maximum power.
• •
D
E
F
G
10
POWERING ON
Press the start/stop button for the cooking zone
you want to use. A flashing 0 and a bip indicate
that the cooking zone is on. You can then
choose the desired power level.
If you do not select a power level, the cooking
zone will automatically turn itself off.
STOP
Press the start/stop button for the cooking
zone used or the power level "
-- " button until 0 0
is displayed.
ADJUSTING THE POWER
Press the + power level button, and a bip* will
confirm that your settings from 1 to P (maximum
power) are actually taken into account.
When it is switched on you can move directly to
maximum power "P" by pressing the "
-- " power
level button.