Caple C601 - Manual (Page 4)

Page 4
C601 user manual.DOC
CONNECTING TO THE ELECTRICAL SUPPLY
Before making the connection, check that: -
The mains voltage is as indicated on the nameplate.
The earth connection is in good working order. If the socket is not easily accessible, the
installation engineer must provide a switch with a contact-breaking gap of 3 mm or more. If
the appliance power lead is not fitted with a plug, use an approved standard type,
remembering that: -
• The green-yellow wire must be used for the earth connection;
• The blue wire is the neutral;
• The brown wire is live;
• The lead must never touch hot surfaces over about 75 degrees C;
• In case of replacement, the power lead must be of type H05RR-F or H05V2V2-F of
adequate gauge (see fig.2) for gas and all-electric appliances, and type FR 3 R3 of
adequate gauge (see fig.2) for gas/electric appliances;
• The power supply lead must only be replaced by a qualified electrician.
IMPORTANT: the manufacturer declines all liability for damage due to failure to comply
with the regulations and standards in force. Check that the appliance is correctly connected
to the earth (see diagrams in fig. 2).
ELECTRIC HOTPLATES
The different heat settings are obtained as follows: -
1 = minimum setting for all hotplates.
6 = maximum setting for normal and rapid hotplates (with red disc).
0 = off.
Pans must never be smaller in diameter than the hotplates and their bottoms must be as flat
as possible (see fig. 12).
IMPORTANT
Never leave hotplates on without pans, except when first used; leave for about 10 minutes
to dry oil or moisture residues;
• If the hotplate is to be out of use for a long time, apply a little grease to its painted
surface.
• Do not allow spills to burn onto the hotplate, requiring the use of abrasive cleaners.