Caple C3232 - Manual (Page 4)

4
Location
Avoid installing the oven too close to a fridge or boiler.
The oven should be installed into an oven housing unit as shown in Figure 1.
Ensure that the surrounding material is heat resistant and non-combustible.
Certain minimum clearances must be allowed for when planning the unit’s location.
Housing dimensions
The unit in which the oven is installed must be manufactured to a modular dimension
of 600mm.
Openings at least 50 mm deep must be cut both in the bottom and in the top of the
unit to ensure adequate ventilation (see figure1 for essential dimensions).
During assembly, particular care must be taken not to pick up the oven by the door.
As a general rule, the oven door should never be forced or subjected to undue
stresses.