Caple WMi1010 - Manual (Page 3)

Page 3
WMi1010 user manual.doc
Removing and cleaning filter
Remove the plastic base guard at the bottom of the machine by
pressing and pulling upwards on the two tabs.
Place a rag under the washing machine to adsorb any residual
water. The filter is located under the base. Turn the filter handle
counterclockwise and pull out the filter. Clean it under running
water. Reinsert the filter and turn the handle clockwise until it is
completely locked. WARNING: water may leak from the filter if it is
not properly tightened. Remember to clean the filter frequently to
avoid excessive clogging.
TECHNICAL FEATURES
Length
595 mm
Depth 530 mm
Height 850 mm
Capacity
Cotton
5 kg max. of dry linen
Synthetic and mixed fabrics. 2,5 kg max. of dry linen
Wool 1 kg max, of dry linen
Voltage and frequency 230 V / 50 Hz
Fuse 10 amp
Water pressure required in water mains min. 0.1 Mpa (1 Bar)
max. 1.0 Mpa (10 Bar)
BEFORE CALLING THE TECNICAL SERVICE CENTRE
Check if plug is inserted
Check that power is available
Check that the door is properly closed
Check that the water tap is open
Check that the water supply hose and water drain hose are not blocked
NOTE: -
if you have to call the service centre, specify the model of your washing
machine and if necessary the Serial Number which is indicated on the rating plate on the
back of the machine.
How to use your washing machine economically and ecologically.
Optimum load - Always try to use the washing machine at full load, as this will use less
water, washing powder and energy than two smaller loads.
You want to use the pre-wash? - Only use the pre-wash for very dirty linen. If you don't
use the pre-wash, you save from 5% to 15% in energy, washing powder, water and time.
Is a high temperature wash required? - To avoid high temperature washing, treat
particularly dirty items with a stain remover or leave the worst stains to soak beforehand.
You will save energy in this way.