Caple RFL70 User Manual

Page 3

Preparation before using

Correct application of the refrigerator

Warning

·Unless recommended by the manufacturer, no mechanical equipment or other means can be adopted to speed up the

defrosting process.

·Unless recommended by the manufacturer, no electrical items can be used in the food compartments.

·The R600a refrigerant and cyclopentane foaming materials used in this refrigerator are all flammable materials, so the

discarded old refrigerators should be isolated from any fire, with disposal by burning forbidden.

Your new refrigerator

· Before using a new refrigerator, remove all packaging materials, including the bottom pad, as well as the foam pads and

adhesive tape in the refrigerator;

·Use damp cloth to clean the refrigerator inside and outside (A small amount of detergent can be added in the warm water

and finally clean water should be used to clean the refrigerator);

·A separate socket with two poles grounded must be prepared, and it is forbidden to share the same multipurpose socket with

other appliances;

·Please be sure to connect the grounding wire well. The socket should have its grounding electrode reliably grounded.

Transport and placement

Transport
· Do not have the refrigerator upside down, horizontally placed, squeezed or shaken. When moving the fridge, do not tilt the
product more than a 45 degree angle.
· When moving, do not use excessive pressure on the door or top cover to avoid deformation.

·The refrigerator can be drawn slightly backwards (no more than 20 degrees), so that it can be moved a short distance with

rear casters rolling.

Placement

·Place the refrigerator in a well-ventilated place. Keep away from heat and direct sunlight. Do not keep it close to damp or wet

areas, to prevent rusting or the insulation weakening.

·The top space should be no less than 30cm. Distance against two sides and back should be no less than 10cm away from the

walls to facilitate the door opening and closing, and to disperse the heat.

·Placed the refrigerator on a flat and solid ground. (If not, it can be levelled by adjusting the levelling toes)

Note

The power line should not be compressed by the refrigerator or other objects, to avoid any accident due to damage of the

power line.

Before connecting to the power source, please carefully check whether the refrigerator has its voltage range identical to the

power supply.

Make sure that the refrigerator is correctly and steadily placed, and that all safety precautions are clearly
understood.

1. Power on

BEFORE SWITCHING THE APPLIANCE ON ALLOW IT TO STAND IN SITU FOR A MINIMUM OF 12 HOURS

After power on, the refrigerator will automatically enter the factory default status.

2. Adding food to the refrigerator

Recommended: Allow the fridge to work for a period of time and the required temperature to be reached or the compressor

has stopped working for the first time, and then add the food into the refrigerator, which is conducive to the first food

preservation.

Tips: When the temperature setting is changed or new food is added, the

refrigerator needs a period of time to have its internal temperature balanced. The

time length depends on the change of the temperature setting, the ambient

temperature, the door-opening frequency and the amount of stored food, etc.