Caple RFZ70 User Manual

Page 3

Preparation before using

Correct application of the refrigerator

Warning

·Unless recommended by the manufacturer, no machinery equipment or other means can be adopted to speed up the

defrosting process.

·Unless recommended by the manufacturer, no electrical appliances can be used in the food compartments.

·The R600a refrigerant and cyclopentane foaming materials used in this refrigerator are all flammable materials, so old

freezers should be isolated from any fire, disposal by burning is forbidden.

New refrigerator

ew refrigerator

· Before using a new refrigerator, remove all packaging materials, including the base pad, as well as the foam pads and

adhesive tape in the refrigerator.

·Use a damp cloth to clean the refrigerator inside and outside (A small amount of detergent can be added to the warm water

and finally clean water should be used to clean the refrigerator).

·A separate socket with two poles grounded should be prepared, and it should not share the same multipurpose socket with

other appliances.

·Please be sure to connect the earth wire well. The socket must have reliable earth connection.

Transport and placement

Transport

·Do not have the refrigerator upside down, horizontally placed, compressed or shaken. When moving the fridge, do not tilt

the product more than a 45 degree angle.

·When moving, do not use excessive pressure on the door or top cover to avoid deformation.

·The refrigerator can be slightly drawn backwards (no more than 20 degrees), so that it could be moved in a short distance

using the rear casters for rolling.

Placement

·The refrigerator should be placed in a well-ventilated place. Keep it away from heat and direct sunlight. Do not situate it close

to damp or water to prevent rusting or the insulation becoming weakened.

·The space above the refrigerator should be no less than 30cm and its two sides and back must be kept no less than 10cm

away from the walls to facilitate the refrigerator door opening and closing and to allow heat dissipation.

·The refrigerator should be placed on a flat and solid ground. (If not, it can be leveled by adjusting the leveling toes)

Note

The power line should not be

The power line should not be compressed

compressed

compressed by the r

by the r

by the refrigerator or other objec

efrigerator or other objec

efrigerator or other objects,

ts,

ts, to

to avoid any accident

avoid any accident

avoid any accident caused by

caused by

caused by damage of the

damage of the

power line.

Before

Before connecting

connecting

connecting to the power source, please carefully check whether the re

to the power source, please carefully check whether the re

to the power source, please carefully check whether the refrigerator has its voltage range identical to the

frigerator has its voltage range identical to the

power supply.

Make sure the refrigerator is correctly and steadily placed

Make sure the refrigerator is correctly and steadily placed on stable flooring

on stable flooring

on stable flooring,,,, a

d tttth

atttt a

allllllll ssssa

affffe

ettttyyyy p

prrrre

ecccca

uttttiiiio

nssss

are clearly understood.

1. Power on

NOTE:

NOTE: THE PRODUCT MUST STAND IN SITUE FOR 12 HOURS BEFORE SWITCHING ON.

After power on, the refrigerator will automatically enter the factory default status.

2. Adding

Adding

Adding food

food

food to

to the refrigerator

the refrigerator

Recommended

Recommended: Allow the fridge to work for a period of time and the required temperature to be reached or the compressor

has stopped working for the first time, and then add the food into the refrigerator, which is conducive to the first food

preservation.

Tips: When the temperature setting is changed or new food is added, the

refrigerator needs a period of t

refrigerator needs a period of time to have its internal temperature balanced. The

ime to have its internal temperature balanced. The

time length depends on the change of the temperature setting, the ambient

temperature, the door

temperature, the door----opening frequency and the amount of stored food, etc.

opening frequency and the amount of stored food, etc.

·The freezer should have its temperature below –18

℃ for long-time preservation of food.

·After purchasing pre-frozen food it be kept in the freezer as soon as possible before it defrosts.

·The hot food should be cooled to the room temperature before adding to the freezer.

·Fruit and vegetables should not be kept in the freezer to avoid frost damage, and no glass containers filled with liquid should

be kept in the freezer to avoid the glass bottle or container from smashing when the liquid expands.

·The frozen food should be sorted with the similar food kept together, to help prevent the doors being unnecessarily open for

a long time, wasting cold energy.

FFFFreezer

reezer

reezer drawers

drawers

The drawers are used to keep the food frozen, and pieces of meat can be cut into small pieces before storage to facilitate

eating. When taking food, first pull the drawer open, push the tray above the drawer in horizontally, and then take out the

food in the lower drawer.

Note: Remember to shut the freezer drawer after use.