Caple INCH4 - Manual (Page 3)

J131 3
of diameter 120 mm. The hood must not be connected
to fuel exhaust flues or to a duct in which hot air is
circulating, or is utilized to remove the fumes from
appliances stocked by an energy different from the
electric one. Pay attention when there is the
contemporary functioning of an hood and a burner
or furnace depending from the air of the surrounding
(stocked by an energy different from the electric one),
because the hood, suctioning, takes away from the
surrounding the air that the burner or the furnace
need for the combustion. So, for a sure functioning,
provide a suitable ventilation of the room by doors,
windows or other technical devices. For the external
exhaust, you have to follow the Authority’s rules. The
external exhaust must not be made in a flue utilized
for the combustible gas of appliances not stocked
by the electric energy.
FILTERING VERSION
INTERNAL RECYCLING (Fig. 6)
When you do not have the possibility to eject the air
outside, you have to utilize a charcoal filter.
The filter purifies the air that after returns in the
surrounding. You have to act as follows :
- Remove the grid 2 (Fig. 1).
- Apply the carbon filter “L” (Fig. 1).
- Replace the grid.
On the connection flange “G”, you have to apply the
filtering deflector “I”, on utilizing the screws 2,9x13.
The deflector is utilized to deviate the air forward, to
avoid to soil the rear wall. This deflector can slide on
its axis to be fixed on an eventual upper wooden
surface.
MAINTENANCE
The effective functioning of the hood depends on the
regularity with which the maintenance operations are
carried out, particularly in the case of the grease filter
and of the charcoal filter. The grease filter, which is
applied on the grill, has the function of catching the
fat and solid particles suspended in the air. It is thus
subject to clogging at various intervals, according to
use and the type of cooking.
In any case it is necessary to clean the filter at least
every two months, for this :
- Remove the filter and wash it with a solution of
lukewarm water and neutral liquid detergent,
allowing the dirt to soften.
- Rinse throughly with lukewarm water; allow to dry
and reapply the filter to the grill.
- When there is a default of washing instructions, you
have a fire risk.
- The filter with red stripes is not washable and it
must be replaced when the stripes appear in the
inferior side.
- The charcoal filter, present only in the filtering
version, has the function of trapping odors and
purifying the air.
The saturation of the charcoal filter occurs after more
or less prolonged utilization, depending on the type
of cooking and on the regularity of cleaning of the
grease filter. In any case it is necessary to replace
the cartridge at least every four months.
The grate made of cold drawn aluminium should be
washed by hand or by dishwasher leaving it to dry
before fitting.
LAMPS’ REPLACEMENT
Disconnect the hood from the main.
Remove the grill.
Utilize only olive-shaped or tubular lamps.
ATTENTION!
UNDER CERTAIN CIRCUMSTANCES DOMESTIC
APPLIANCES MAY BE DANGEROUS
- Do not check filters with hood running
- Do not obstruct vented outlets
- Do not touch lamps or lamp-covers after long
periods of working
- Not to be used over eye-level grill
- No food must be cooked flambé underneath the
hood
- The use of an unprotected flame is dangerous for
the filters and could cause fires
- When frying foods, never leave the pan alone,
because the cooking oil could flare up
- Before performing any maintenance operation,
disconnect the hood from the mains
- The manufacturer refuses to accept any
responsability for eventual damages to the hood,
because of failure to observe the above instructions.