Caple MI360 - Manual (Page 11)

for the 3rd speed. In order to activate the intensive speed,
press the button for 5 seconds regardless of the status of the
hood. For each speed only the led indicating the set speed
will turn on. The intensive speed is indicated by the flashing
of the led indicating speed 3. The duration of the intensive
speed is 10 minutes; after this time the hood goes back to
the last set speed.
In order to remove the intensive speed press the power button
and the hood will switch off, or press the Fan speed button
and the speed goes back to the previously set one. Speed of
the hood with cyclic trend.
Light button (C)= There are three light levels: High, medium,
low.
From the off position press once for the high level, twice for
the medium level, three times for the low level and four times
to turn the lights off.
The level of the lights has a cyclic trend: High, medium,
low, off.
ATTENTION! This function is only available with halogen
lamps and NOT with LED lamps.
Timer button (D) = With any type of speed (excluding the
intensive speed), by pressing the button, the timer function
is activated for 15 minutes. After this time has elapsed the
hood will turn off (motor and any light on).
If the product purchased is equipped with optional features
such as the courtesy lights or side spotlights, keep the Timer
button pressed for 4 seconds to turn them on. Complete the
same operation to turn them off.
Lights indicator (E) = The lights indicator will switch on when
the lights are on at any level.
Filters indicator (F) = After 30 minutes of operation, the led
of the filters indicator will switch on, not flashing indicating
that the anti-grease filters have to be washed. To reset the
function (with the hood off), press the Fan speed button for
5 seconds. After this operation, the led of the filters indicator
turns off and the setting of the 30 hours starts again from
the beginning.
After 120 hours the led will flash continuously. This means
that the carbon filters have to be replaced (if present). To reset
the function (with hood off) press the Fan speed button for 5
seconds. After this operation, the led of the indicator turns off
and the setting starts again from the beginning
Clean air indicator (G).
With the hood off, press the Power button (A) for 5 seconds to
activate the clean air function. This will switch on the motor
at speed 1 for 10 minutes every hour. The light indicator will
switch on without flashing and the led of the 1st speed will
switch on. In the remaining 50 minutes the light indicator will
flash. The function can be deactivated by pressing any button
except for the light button.
THE MANUFACTURER DECLINES ALL RESPONSIBILITY
FOR EVENTUAL DAMAGES CAUSED BY BREACHING THE
ABOVE WARNINGS.
- 11 -