Campomatic WM909XE Turbologic XXL - Manual (Page 33)

FAILURE CODE
PROBABLE FAILURE THE PROCESS
TO BE DONE
The water level in your
machine is below heater. The
pressure of your water supply
may be low or locking.
Turn on the tap
to the end.Water
may be cut,
check it.If the
problem is still
continuing,your
machine will
automatically
stop after a
while.Unplug
your machine,
turn off the tap
and apply to the
nearest
authorized
service.
The pump has failed or the
pump filter is obstructed.
Clean the pump
filter.If the
problem
persists,apply to
the nearest
authorized
service.(*)
There is an excessive amount
of water in your machine.
Your machine
will automatically
drain the water.
After your
machine has
completed the
draining
process,shut
down your
machine and
unplug. Close
the tap and
apply to the
nearest
authorized
service.
(*) See the section regarding the maintenance and cleaning of your machine.
32