Campomatic WM80LS - Manual (Page 14)

Service Instructions
Installation environment requirements
Ambient temperature
To minimize the vibration or unbalanced load, the wood floor has to be
reinforced. The carpet and the soft floor tile surface may cause
vibration and slight movement of the washing machine in operation.
Before you install the washing machine, select a location with the
following characteristics:
The washing machine cannot be positioned in a place where water
freezes easily, because some water may be left in the water valve,
drainage pump and water pipe. Freeze in the pipeline may cause
damage to the belt, drainage pump and other parts.
Your washing machine should be positioned in the environment with
ambient temperature of 0℃~40℃ and relative air humidity below 95%
(when the temperature is 25℃), thus the washing machine can be used
in a convenient and safe way.
For safe and proper operation, the space for positioning your washing
machine should be:
Make sure that the washing machine does not stand on its power cord.
Ventilation openings must not be obstructed by carpeting when the
washing machine is installed on a carpeted floor.
◆ Do not position the washing machine on a platform or a structure with weak
support.
◆ A hard, level surface (if the surface is uneven, see “Adjusting the leveling leg” on
page 15).
◆ Avoid direct sunlight, with adequate ventilation. (The washing machine shall not be
installed in a bathroom or a wet room.)
◆ Room temperature shall not fall below 0℃.
◆ Away from sources of heat such as coal or gas stove.
Installation in a limited space
Two sides – 25 mm (1 in)
Back – 51 mm (2 in)
Top – 25 mm (1 in)
25mm
25mm
51mm