Campomatic TL07T - Manual (Page 6)

5
I ns ta lla tion o f t he w a s her
Remove package
Installation of drain hose
Remove package and take out the bottom board of
the cabinet on the foam cover.
Open the lid of washer's door and take out accessories.
A trial operation or washing on the foamed cushion is
strictly forbidden.
Completely sleeve the drain
hose over the sewer.
Fix and tighten it with a hoop.
( As shown in the figure )
Base foamed cushion
Installation of water inlet hose
Water inlet adapter
The water inlet consists
of connection socket and
speedy connector.
Connector
socket
Fastening
screw
Lock nut
Speedy
connector Slide
jacket
+
+
+ +
F O R L O W E R D R A IN S Y S T E M O NLY
Placement of water drain hose
Under3m
Under 15cm
If the water drain hose shall
be extended, its length shall
not exceed 3 meters,
otherwise it will affect the
water discharging time.
The placed height of water
drain hose shall not exceed
15cm.
Do not bend the water
drain hose and place
it under the washer.
The height of drain hose (“a”)should between 86-100 cm.
Diameter of “b”shuld not less than 3 cm, and flow capacity
not less than 40 L/Min.
F O R U P P E R D R A IN S Y S T E M O NLY
86~100 cm
Placement of upper water drain hose
+ +