Campomatic FRZ360N - Manual (Page 8)

GB 8
913
POSITIONING AND INSTALLING THE APPLIANCE
2e Replace the door.
2f Fit the pin from the lower hinge onto that supplied, then fi t the hinge and tighten the door.
2g Replace the hole plugs in the plinth with those supplied.
2h Replace the plinth by pushing it.
REVERSING THE VERTICAL HANDLE
If the appliance is delivered with the vertical handle already fi tted and the door opening direction needs to be
changed, the handle itself must also be moved as follows:
2i Remove the handle by unscrewing the two fi xing screws.
2l Remove the hole plugs on the opposite side of the door by pressing them lightly.
2m Rotate the handle 180° and fi t it in place using the two fi xing screws. Insert the plugs in the holes left on the
opposite side.
FITTING THE VERTICAL HANDLE
If the appliance is supplied with a separate vertical handle, it can be fi tted as follows:
2i Take the handle and screws supplied.
2i Position the handle over the holes and fi x it in position using the screws supplied.
2e
2g
2n
2h
2p
2f