Campomatic CT1190 - Manual (Page 9)

8
7) Press to confirm, the code will be stored to the base and a tone sounded.
 BASE DEFAULT
This function allows the user to restore the base setting to the factory default.
1) Press key, then using ▲ or ▼ key to select BS DEFAULT item.
2) Press key to confirm.
3) The user will be prompted to enter the PIN CODE, the display shows PIN?, then press numerical
keys to input code.
4) If the PIN code is validated all base settings will be returned to the factory default.
Handset Menu function 4: HS SETTINGS
The user is able to change a number of the settings for the handset to their own individual preferences.
Using ▲ or ▼ key to select HS SETTINGS. Then you can do below:
 ALARM
The user is able to set the alarm on the handset and adjust the alarm settings.
1) Press key, the first sub-menu is ALARM item.
2) Press key to confirm.
3) Press
▲ or ▼ key to select ON or OFF, and press
to confirm .Selection of ALARM OFF will
turn the alarm off, and the user is dropped back to the “ALARM” menu. Selection of ALARM ON
option will turn the alarm on, then the user will be requested to set the alarm time.
4) After select ON, press key to start the time settings of alarm, 12- 00 displayed with “12” flashing,
5) Press ▲ or ▼ key to edit the alarm time (including AM/PM)
6) Press key, the user will be presented with a further option to select to SNOOZE ON or
SNOOZE OFF to enable or disable the snooze function on the alarm.
7) Press key to confirm your selection. And the alarm icon will show on LCD.
 Startup alarm:
In idle state, the alarm will ring at very sharp hour you have set.
 Intermit alarm:
During the alarming, press any key except (HANG UP/POWER OFF key), and will begin to ring
after 6 minutes. When a call comes, the alarm will be intermitted too.
 Close alarm:
Press (HANG UP/POWER OFF key) to close alarm or enter alarm setting state, select OFF.
 RING SETUP
The user is able to change the handset ringing on internal calls and External calls. There are 10 ringer
melodies and 5 different volume levels can be set.
1) Press key, then using ▲ or ▼ key to select “RING SETUP” item.
2) Press key to enter.
3) Press ▲ or ▼ key to select the INT RING and EXT RING setup.
4) Press key to confirm.
5) Press ▲ or ▼ key to select the MELODY and VOLUME setup.