Burst Electronics VS8x8 - Manual (Page 8)

operating mode. The unit will now enter the
appropriate operating mode whenever it is
powered up. The unit can be reprogrammed a ny
time and the internal EEPROM is rated for an
excess of 10,000 write operations.
Operation
The following paragraphs detail the operating
procedures for each of the four operating modes
that can be programmed into the VS8x8 Video
Crosspoint Switch.
Manual Mode (Mode 1)
When operating in this mode, the operator sets
the front panel thumbwheel switches
corresponding to the specific output channel.
Setting the thumbwheel switch to the values of 1
through 8 will connect that video input to the
specified outp ut. Setting the thumbwheel switch
to a value of 0 or 9 will turn off the output. When
the unit detects a change on the front panel
thumbwheel switches, it will wait for the vertical
sync interval of the current setting before turning
off the output, and will then wait for the sync
interval of the new input channel before activating
the new selection. In this mode, the front panel
SET LED is always on, indicating that the video
outputs are always set to correspond with the
thumbwheel settings.
Triggered Manual Mode (Mode 2)
This mode is similar to the Scanned Manual
Mode with one exception. When a change is
VS8x8 Crosspoint Video Switch 8