Burst Electronics LG-1 - Manual (Page 4)

Connect a video source to the Video In of the LG
and connect Video Out to your monitor. Video will
pass through the LG without power applied.
Plug in and connect the 12Vdc wall module to the
LG and turn power on.
After LOGOGEN is installed, select the appropriate
COM port that is being used (see COM).
The RS232 installation is now complete and the LG-
1+ is ready for use.
Hardware Installation USB
Place the LG Program Files Installation CD into your
CD-ROM drive. Connect the LG hardware to power
and turn the unit on. Connect the USB2.0 cable to
the computer and then to the LG hardware. A pop-
up window appears stating New Hardware Found
(see Figure USB1)
(Figure USB1)
LG-1+ and LG-4 Logo Generators 3