BUG-O Systems STW-2000 - Manual (Page 6)

6
CONTROLS (MAIN):
VOLTAGE CONTROL: Regulates welding voltage for the assigned feeder
WIRE SPEED CONTROL: Regulates the wire feed speed for the assigned feeder
WIRE JOG: Allows wire to be fed without closing the weld current contact
WIRE FEEDER POWER INDICATOR LIGHT: Illuminate when power is being supplied to the assigned
wire feeder
WIRE FEEDER ON/OFF SWITCH: Allows operator to turn power on or off to the assigned wire feeder.
SHIELD GAS PURGE: Allows operator to activate shield gas solenoid to purge welding gun and check
the gas rate on the units regulators
MAIN WELD CYCLE START: Initiates automated weld cycle
MAIN WELD CYCLE STOP: Halts automated weld cycle
TRAVEL MANUAL JOG: Allows operator to move the unit forward or backward without welding
EMERGENCY STOP: When pressed causes all functions to stop
PROGRAMMING CENTER: See controls for programming center pg. 7
Voltage
Control (A)
Wire Speed
Control (A)
Wire Jog (A)
Wire Feeder
Power Indicator
Light
Feeder
On/Off (A)
Shield Gas
Purge (A)
Main Weld
Cycle Start
Travel Manual
Jog
Main Weld
Cycle Stop
Shield Gas
Purge (B)
Feeder
On/Off (B)
Wire Feeder
Power Indicator
Light
Wire Jog (B)
Wire Speed
Control (B)
Voltage
Control (A)
Programming Center
Emergency Stop