BUG-O Systems Speed Weaver II - Manual (Page 4)

5
The SPEED WEAVER II is a compact, precision, all-position machine,
designed for maximum versatility in oscillation. Its solid-state controls with
graduated dials provide adjustable and readily repeatable control of critical
weld parameters.
The unit will oscillate up to 160 cycles per minute at a stroke of .125" (3 mm).
A stroke adjustment of .125 to 2" (3 to 51 mm), a wide speed range of 6 to
152 ipm (152 to 3810 mm/m), and independently adjustable left and right
dwell time of 0 to 3 seconds will cover any commonly encountered welding
requirements.
The Speed Weaver II is designed to mount on any BUG-O carriage or fixture.
Its lightweight permits easy movement of the machine from one welding
location to another.
INTRODUCTION:
FEATURES:
• All Solid-state control circuitry
• Non-contact proximity sensors for end of stroke limits
• Minimum stroke .125" (3 mm) to 2" (51 mm) maximum
• High speed oscillation - 160 cycles/min at .125" (3 mm) stroke
• Wide speed range, 6-150 ipm (152-3810 mm/m)
• New welding mode: tractor stop during dwell
• Positive holding torque during dwell
• Independent dwell control, each side, 0-3 seconds
• Digital dial control with lock for weave amplitude
• Straight line mode: (stringer pass)
12