BUG-O Systems Elbow Cutters 3rd Axis - Manual (Page 5)

5
Data Entry
When entering data on the keypad, multiply inches, degrees, or seconds by 100 and enter the number
without a decimal point. For metric dimensions, multiply mm x 10 cm x 100.
For Example: 350 for 3.5 inches,
800 for 80mm on metric machines
1500 for 15°
Press the return button after the number is entered.
Data required:
TYPE 1: Requires 1. Small diameter (pipe being cut).
2. Large diameter (pipe it fits on).
3. Torch Rotation Angle
TYPE 2: Requires 1. Small diameter
2. Large Diameter
3. Offset distance between centerlines
4. Torch Rotation Angle
TYPE 3: Requires 1. Small diameter
2. Large diameter
3. Offset
4. Angle between pipes
(No torch rotation.)
TYPE 4: Requires: 1. Small diameter
2. Cutback distance
3. Angle of mitre cut
(Rotation automatically sets to mitre angle)
TYPE 5: Requires: 1. Small diameter
2. Large diameter
3. Rotation Angle
For plasma cutting, a value for the time delay is also required to allow for the delay in striking the arc.
A commonly used delay is 3 seconds (enter 300 on the terminal keypad).