Preface – BUG-O Systems Flame Cutting User Manual
Page 5
5
PREFACE
This booklet has been prepared to show how to
operate and maintain “Gas Cutting” equipment.
Specifically, it shows how to set up, light, set travel
speed and position the “Cutting Torch” for a quality
cut.
WELD TOOLING CORPORATION. 2008
280 TECHNOLOGY DRIVE
CANONSBURG, PA 15317 U.S.A.
PHONE: (412) 331-1776
FAX: (412) 331-0383
For Additional Information Please
Go to Our Website: www.bugo.com
A DIVISION OF WELD TOOLING CORPORATION
3001 WEST CARSON STREET PITTSBURGH, PA USA 15204
PHONE: 1- 800-245-3186 www.bugo.com FAX: 1- 412- 331- 0383
Flame Cutting Handbook.p65
5/9/2007, 8:06 AM
5
See also other documents in the category BUG-O Systems Equipment:
- HOB-O (18 pages)
- Side Beam System (17 pages)
- Trac-Bug (21 pages)
- Programmable Shape Machine (31 pages)
- Programmable Shape Machine (22 pages)
- K-BUG 1200 (21 pages)
- Programmable Gantry System (36 pages)
- CWP-5 (40 pages)
- CWP-7 (41 pages)
- CWP-11 (47 pages)
- CWP-18 (41 pages)
- CB-1P (37 pages)
- CB-3 (30 pages)
- CW-5 (34 pages)
- CWE-5 (40 pages)
- CW-5AX (41 pages)
- CW-7 (43 pages)
- Elbow Cutters 3rd Axis (14 pages)
- CW-11 (46 pages)
- CW-18 (41 pages)
- SE-4PD (48 pages)
- SE-4PTD (40 pages)
- SE-4PD (43 pages)
- FTS-1025 (17 pages)
- BVW-1000 (26 pages)
- AGS-4100 (46 pages)
- Standalone CDS Linear Weavers (20 pages)
- BGW-6000 (47 pages)
- Standalone Pendulum Weavers (18 pages)
- DC IV v.2 (22 pages)
- UNI-BUG II (21 pages)
- PBM-2002 (17 pages)
- BEAM BUG III (23 pages)
- SPB-3000 (26 pages)
- Speed Weaver II (14 pages)
- UNI-BUG III (44 pages)
- CAS-2050 (20 pages)
- BUG-6554 (32 pages)
- CAS-2060 (20 pages)
- BUG-9874 (12 pages)
- STW-2000 (32 pages)
- STW-3000 (26 pages)
- Stiffener Welder (29 pages)
- MDS-1004 (14 pages)