BUG-O Systems Flame Cutting - Manual (Page 17)

17
(5) The gears in the machine may eventually
become worn, permitting excessive backlash.
With the machine on the track, and the clutch
engaged the BUG-O should not move more
than 1/8 inch (3mm) back and forth when hand
pressure is applied in these directions.
C. START UP PROCEDURE
1. HOOKING UP
a. Secure cylinders in upright position. Blow out
gas and oxygen supply station outlets to
remove any dust and grit particles.
b. Attach regulators to outlet. Finger tighten
connections. Use a wrench to make snug.
Be careful not to strip the threads.
c. Attach hoses to regulators. Finger tighten
connections. Use a wrench to make snug. Be
careful not to strip the threads.
d. Place BUG-O in approximate position to make
cut.
e. Insert torch into holder on the BUG-O.
f. Attach hoses to the torch. Finger tighten
connections. Use a wrench to make snug.
Be careful not to strip the threads.
Flame Cutting Handbook.p65 5/9/2007, 8:06 AM 17