Desa VF-24N-BTB - Manual (Page 5)

www.desatech.com 111826-01G 5
PRODUCT
IDENTIFICATION
Figure 1 - Product Identification
LOCAL CODES
Install and use heater with care. Follow all local
codes. In the absence of local codes, use the lat-
est edition of The National Fuel Gas Code ANSI
Z223.1/NFPA 54*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
Hand-Held
Remote Control Chassis
Assembly
Control
Knob
Log Set
Assembly
UNPACkING
CAUTION: Do not remove the
data plates from the grate as-
sembly. The data plates contain
important warranty and safety
information.
1. Remove log set assembly from carton.
Note: Do not pick up assembly by logs. This
could damage heater. Always handle assembly
by grate.
2. Remove control cover floor media components.
3. Remove all protective packaging applied to
log set for shipment.
4. Check all items for any shipping damage. If
damaged, promptly inform dealer where you
bought heater.
PRODUCT FEATURES
OPERATION
This heater is clean burning. It requires no outside
venting. There is no heat loss out a vent or up a
chimney. Heat is generated by realistic flames and
glowing ceramic logs/coals. This heater is designed
for vent-free operation with flue damper closed. It has
been tested and approved to ANSI Z21.11.2 standard
for unvented heaters. State and local codes in some
areas prohibit the use of vent-free heaters. This heater
may also be operated as a vented decorative (ANSI
Z21.60) product by opening the flue damper.
SAFETY DEvICE
This heater has a pilot with an Oxygen Deple-
tion Sensing (ODS) safety shutoff system. The
ODS/pilot is a required feature for vent-free room
heaters. The ODS/pilot shuts off the heater if there
is not enough fresh air.
ELECTRONIC IGNITION SYSTEM
This system has an electronic ignitor. This system
requires no matches or other sources to light heater.
Receiver requires 4 AA batteries (included), hand-
held remote control requires a 12-volt battery and
a 3-volt button cell battery for the LCD display
(both included).
OPTIONAL REMOTE
CONTROL ACCESSORIES
There are two optional remote accessories avail-
able for the PDG models that come standard with
the BTB models:
• wall switch
• hand-held ON/OFF remote
See Accessories, page 25.
Chassis
Assembly
Log Set
Assembly
Selector
Switch
Flame
Adjustment
Knob
Control
Knob
Selector
Switch
Flame
Adjustment
Knob
BTB Models
PDG Models
Remote
Receiver
Electronic
Ignitor
Electronic
Ignitor