Broadata Communications 1200E Series - Manual (Page 7)

BCI 1200E User’s Manual
Fiber Optic Serial Digital Audio Transport System
Broadata Technical Support, (800) 214-0222 8
2.1 Cabling and Connectors
In order to setup the BCI 1200E properly, make sure to observe
the following instructions when installing the proper cables. The
1200E requires two parts to the cabling setup: the electrical
and the optical. For the optical part, observe the following
procedures, as there are various types of optical connectors as
illustrated on the following page.
2.1.1 Electrical Cable Connection
The only available cable connections on the electrical side are
for audio sources.
Proceed with the following instructions when connecting the
various electrical devices.
2.1.1.1 Audio Connection
Perform the following steps to insure a proper audio connection:
1. At the near end (the transmitter unit), connect the user’s
audio sources to the 1200E unit’s audio input ports. (See
Figure 2-2).
2. At the far end (the receiver unit), connect the user’s audio
receivers to the corresponding audio output ports on the
1200E receiver unit.
3. Terminal block connectors are provided for the audio feeds
(see Figure 2-2). Figure 2-3 illustrates the terminal block
pin assigment for the 1204E (Figure 2-3(a)) and 1208E
(Figure 2-3(b)).