Broadata Communications Mini-DVI-WP Series - Manual (Page 5)

BCI Mini-DVI-WP User’s Manual
Wall Plate Miniature Multimode Fiber Optic DVI Transmission System
Broadata Technical Support, (800) 214-0222 6
2.0 SETUP
The BCI Mini-DVI-WP Series units are used in pairs. One
Mini-DVI-WP-T transmitter unit is located at the near-end and connected
through one optical fiber, to the Mini-DVI-WP-R receiver located at the
far-end of the link. Figure 2-1 depicts a typical installation for the
Mini-DVI-WP-T/R.
Figure 2-1
Mini-DVI-WP Setup
2.1 Mounting
Before installing the units into your wall plate housing, make
sure there is enough space to pull and connect both the electrical
and optical cables without stressing them beyond the
manufacturer’s limitations (also known as the minimum bend
radius).
2.2 Cabling and Connectors
In order to setup the BCI Mini-DVI-WP properly, make sure to
observe the following instructions when installing the proper
cables. The Mini-DVI-WP requires two parts to the cabling
setup, the electrical and the optical.
Media Room Wall
Mini-DVI-T-WP
DVI Input
(with DDC)
Video Projector Room
Mini-DVI-R-WP
DVI Output
(with DDC)
1 Multimode
Fiber