Broadata Communications LBO-DVI Series - Manual (Page 6)

LBO-DVI User’s Manual
Directly Pluggable Link Bridge TM Fiber Optic DVI Transmission System
Broadata Technical Support, [email protected] 7
2.0 SETUP
The BCI LBO-DVI Series units are used in pairs. One LBO-DVI-T
transmitter unit is located at the near-end (source) and connected through
one optical fiber, to the LBO-DVI-R receiver located at the far-end (sink)
of the link. Figure 2-1 depicts a typical installation for the LBO-DVI-T/R.
Figure 2-1
LBO-DVI Setup
2.1 Mounting
Before installing the units into your housing, make sure there is
enough space to pull and connect both the electrical and optical
cables without stressing them beyond the manufacturer’s
limitations (also known as the minimum bend radius).
2.2 Cabling and Connectors
In order to setup the BCI LBO-DVI properly, make sure to observe
the following instructions when installing the proper cables. The
LBO-DVI requires two parts to the cabling setup, the electrical
and the optical.