Brinly STH-420 BH Lawn Sweeper - Manual (Page 13)

1009727-A 13.
ASSEMBLY
================================================================================================
67
17
38
22
69
38
40
40
22
69
17
Using the hardware in Panel 10, assemble one 3/8” Nut
(17) on each end of the Hamper Stop Rod (67) until it is
approximately in the center of the threads.
67 17
Assemble each end of the Hamper Stop Rod (67) through
the holes on the front of the Upper Side Tubes (38) and
Lower Side Tubes (69).
Using the remaining hardware in Panel 10, assemble one
3/8” Lock Nut (22) on each end of Hamper Stop Rod (67).
Tighten the Lock Nut (22) until Hamper Stop Rod (67) is fl ush
with the top of the Lock Nut (22).
Note: Hold the Hamper Stop Rod (67) with Pliers while
tightening the Lock Nuts (22).
Upper and Lower Side Tubes should be trapped between
the Nut (17) and Lock Nut (22) on the Hamper Stop Rod (67)
but still loose enough to pivot freely. If the tubes do not pivot
freely, loosen Nut (17).
Pull up on bottom of Hamper (40) from “J” Channel and hook
”J” Channel onto Hamper Stop Rod (67).
Snap side fl aps to Hamper (40) bottom as shown. Note: Flap
should be on the outside of Lower Side Tubes (69) after
assembly.
Figure 10
Hook
Snap
Snap
“J” Channel