Brinly PA-40 BH Plug Aerator - Manual (Page 11)

L-1762 Rev. E 11
MAINTENANCE
SPECIFICATIONS
SERVICE
Should rust develop, sand lightly and then paint area with
enamel.
Periodically check all fasteners for tightness.
IMPORTANT:
Apply a drop of lubricating oil to each Nylon Bearing and the
Aerator Axle before each use.
To prevent rust on plugging spoons, apply a light coat of
oil on the working areas of spoons after each use. Should
rust appear on any other part of your Aerator, sand lightly to
remove rust and coat lightly with enamel.
Plugging spoons are manufactured with special steels and
are heat treated to resist wear of abrasive soil. Striking
sub-surface objects can cause spoon breakage. Contact
our Customer Service Department to purchase replacement
Plugging Spoons (Part# B-4855-10). See “GETTING
QUALITY SERVICE”.
Periodically check the spoons remove any debris which
might build up and restrict their action.
After each use, service unit as described and store in a dry
area, shielding tines to avoid injury.
PA-48
Maximum Towing Speed ............................................. 5 MPH
Aerator Capacity .........................................................200 lbs.
Empty Weight ...............................................................90 lbs.
Maximum Towing Weight ............................................290 lbs.
Recommended Tire Pressure ........................Semi pneumatic
USE OF ADDITIONAL WEIGHT
The weight required to give a recommended penetration
of approximately two to three inches will vary according
to soil type and conditions. Concrete blocks, patio blocks,
sand bags, or any other type of weight can be added to
Aerator Tray as required. Weight can be secured by using
tie downs through holes in Tray Flanges. Tie downs are not
furnished with your unit. Usually three Concrete Blocks will
be sufficient, but more or less weight may be required.
Drive your tractor to location to be Aerated. •
Lower Aerator to Operating Position. •
Drive the Tractor FORWARD approximately ten feet and •
stop.
Observe the operation- there should be a Plug hole •
approximately every ten to twelve inches and not more
than three inches deep.
Add or remove weight to obtain this condition. •
MAINTENANCE:
The key to years of trouble-free service is to keep your
Aerator clean and dry.
Never allow wet material to remain in Tray for extended
periods of time.
Occasionally check all moving parts for free movement and,
if necessary, lubricate with oil.
PA-40
Maximum Towing Speed ............................................. 5 MPH
Aerator Capacity .........................................................150 lbs.
Empty Weight ...............................................................66 lbs.
Maximum Towing Weight ............................................216 lbs.
Recommended Tire Pressure ........................Semi pneumatic
Quality Continues With Quality Service
We provide a process to remedy your questions or problems.
Follow the steps below to get answers to any questions you may have about your product, or to order replacement parts:
1. Refer to your attachment and machine operator manuals.
2. In North America and Canada, call 1-877-728-8224 and provide product serial number and model number.