Denon TU-1510AE - Manual (Page 6)

2
ENGLISH
Getting
started
Connections
Operations
Troubleshooting
Specifications
Index
About the remote control
Inserting the batteries
q Remove the rear cover of the
remote control.
w Set two R03/AAA batteries in
the battery compartment in the
indicated direction.
e Put the rear cover back on.
NOTE
• Replace the batteries with new ones if the unit does not operate
even when the remote control is operated close to the unit.
• The supplied batteries are only for verifying operation.
• Insert the batteries in the proper direction, following the “q” and
“w” marks in the battery compartment.
• To prevent damage or leakage of battery fluid:
• Do not use a new battery with an old one.
• Do not use two different types of batteries.
• Do not attempt to charge dry batteries.
• Do not short-circuit, disassemble, heat or dispose of batteries in
a fire.
• If the battery fluid leaks, carefully wipe the fluid off the inside of the
battery compartment and insert new batteries.
• Remove the batteries from the remote control if it will not be used
for a long time.
• Dispose of batteries in accordance with local regulations on battery
disposal.
Cautions on handling
• Before turning the power operation switch on
Check once again that all connections are correct and that there are
no problems with the connection cables.
• When leaving home for long periods of time, be sure to unplug the
power cord from the power outlet.
• About condensation
If there is a major difference in temperature between the inside
of the unit and the surroundings, condensation may form on parts
inside the unit, causing the unit to fail to operate properly.
If this happens, let the unit sit for an hour or two with the power off
and wait until there is little difference in temperature before using
the unit.
• Cautions on using mobile phones
Using a mobile phone near this unit may result in noise. If that
occurs, move the mobile phone away from the unit when it is in use.
• Moving the unit
Turn off the power and unplug the power cord from the power outlet.
Next, disconnect the cables connected to other system units before
moving the unit.
• Store these instructions in a safe place
After reading, store these instructions along in a safe place.
Cautions on installation
Noise or disturbance of the picture may be generated if this unit or
any other electronic equipment using microprocessors is used near
a tuner or TV.
If this happens, take the following steps:
• Install this unit as far away as possible from the tuner or TV.
• Run the antenna wires from the tuner or TV away from this unit’s
power supply cord and input/output connection cables.
• Noise or disturbance tends to occur particularly when using indoor
antennas or 300 Ω feeder wires.
We recommend using outdoor antennas and 75 Ω coaxial cables.
Operating range of the remote control
Operate the remote control while pointing it at the remote sensor.
30°
30°
Approx. 8 m
NOTE
The unit may function improperly or the remote control may not
operate if the remote control sensor is exposed to direct sunlight or
strong artificial light from a fluorescent or infrared light.
Getting
started