BrightSign HD1010 Hardware - Manual (Page 9)

BrightSign Compact
This information applies to a product under development. Its characteristics and specifications are subject to change without notice. Roku assumes no
obligation regarding future manufacturing unless otherwise agreed to in writing.
www.rokulabs.com © Roku 2008
Ethernet
The Brightsign Compact has a standard RJ45 connector for 10/100 base T Ethernet. Maximum cable
length is 100 Meters. The pinout of the RJ45 is as follows:
pin Description pin Description
1 TX+ 2 TX-
3 RX+ 4 RC to ground
5 RC to ground 6 RX
7 RC to ground 8 RC to ground
USB
The Brightsign Compact has a high speed (480 mbit) USB host port. Maximum cable length is 5 Meters.
The port has the following pinout:
pin Description pin Description
1 VBUS 2 D-
3 D+ 4 Ground
DB15 VGA connector
The VGA connector is able to output RGB video. The connector has the following pinout:
pin Description pin Description
1 RED analog video output 2 GREEN analog video output
3 BLUE analog video output 4 NC
5 Digital ground 6 Analog ground
7 Analog ground 8 Analog ground
9 +5V DDC supply 10 Digital ground
11 NC 12 DDC SDA
13 HSYNC output 14 VSYNC output
15 DDC SCL
Triple RCA Component HD video connector
The component triple RCA connector is a able to output the following formats:
 480P video: Y from Green jack, Pr from Red jack, and Pb from Blue jack.
 720P video: Y from Green jack, Pr from Red jack, and Pb from Blue jack.