BrightSign XD230 Hardware - Manual (Page 14)

BrightSign XD230, XD1030, XD1230
11
All information provided in this reference manual applies to products under development. The characteristics and specifications of these products are subject to
change without notice. BrightSign assumes no obligation regarding future manufacturing unless otherwise agreed to in writing. © BrightSign LLC, 2012
HDMI Out Connector
The HDMI-out connector is used to send digital video and audio to HDMI-enabled sink devices. The following table
illustrates the pinout of the HDMI connector:
pin Description pin Description
1 TX2p 2 Ground
3 TX2n 4 TX1p
5 Ground 6 TX1n
7 TX0p 8 Ground
9 TX0n 10 TXCp
11 Ground 12 TXCn
13 CEC 14 NC
15 DDC SCL 16 DDC SDA
17 Ground 18 +5V DDC
19 HDP (Hot Plug Detect)
HDMI In Connector
The HDMI In accepts inputs of up to 1920x1080@60p, with 24-bits RGB. The signaling conforms to the DVI 1.0, HDMI
1.4, and HDCP 1.2 standards. The HDMI signaling has CEC (but no ARC or HEC) functionality. The CEC channel is
electrically coupled to the corresponding signal on the HDMI output, and the CEC commands will pass through players
even when they do not have power.
3.5mm IR Out
The IR blaster generates a space-encoded (NEC) signal. The two transported bit values of the NEC signal (0 and 1) are
encoded using differing lengths of low-time IR pulses.