BrightSign LS322 Hardware - Manual (Page 11)

LS322, LS422 User Manual and Operations Guide
8
All information provided in this reference manual applies to products under development. The characteristics and specifications of these products are subject to
change without notice. BrightSign assumes no obligation regarding future manufacturing unless otherwise agreed to in writing. © BrightSign LLC, 2015
A button/LED/IR board can be used to demonstrate the GPIO and IR functions on a BrightSign player. This board is built
by a third-party manufacturer and can be purchased upon request.
RJ45 Ethernet
The LS322 and LS422 have a single 10/100 RJ45 port for networking. The maximum length for the Ethernet cable is 100
meters. The following table illustrates the pinout of the RJ45:
pin Description pin Description
1 TX+ 2 TX-
3 RX+ 4 RC to ground
5 RC to ground 6 RX-
7 RC to ground 8 RC to ground
SD Port
The LS322 and LS422 have a card slot that supports SD, SDHC, and SDXC cards. It is capable of streaming video at
25Mbps or streaming three stereo PCM audio tracks simultaneously.
On-Board LEDs
LS322 and LS422 have a single red LED located on the side of the device to indicate that the power is on.