Blu Bathworks TEP211 - Manual (Page 3)

2014-02
1 866 907 0122 blubathworks.com
2
Step 1 - Basin spout
• Screw the rod (1) on the pipe (2).
Step 2 - Assembly of the Control Fixing Bracket
to the In-wall Plate
• Finish the wall by tiling or using drywall. Using
the trim plate, the control fixing brackets must
be positioned using the supplied in-wall rough-in
plate with their centres 100mm apart.
• 40mm diameter hole is required for the electronic
controler.
• 15mm diameter hole is required for the spout.
• Conduits should be used in the walls where
necessary to protect the cables and allow
maintenance.
• Attach the control fixing brackets using the four
small screws supplied in the plastic bagset for
the control fixing brackets.
Note: Keep the slipin away from plaster by wrapping it in plastic or connect it after step 5 of this install guide.