Blu Bathworks TSP100 - Manual (Page 4)

2014-01
1 866 907 0122 blubathworks.com
®
3
Installation Procedure for Three-Hole
Refer to illustration 2
1. Remove the escutcheon rings from the cartridge bodies.
2. Place the cartridge bodies up through their designated holes and then screw the escutcheon rings back on, making
sure that the hole for the set screw faces backwards.
3. Tighten the cartridge bodies into place by tightening the lock nuts so that the rubber washers are pressing up
against the mounting service.
4. Place the control handles into the escutcheon rings and then tighten the set screws with the provided Allen wrench
to keep them in place.
5. Remove the locking nut and rubber washer from the mounting screw.
6. Place the faucet through the designated faucet hole of the mounting surface.
7. From below the mounting surface, slide the rubber pad and metal mounting support onto the mounting screw so
that the rubber pad presses up against the mounting surface.
8. Screw the locking nut onto the mounting screw by hand until tight, then turn an additional 1 /
4
turn using a wrench. Be
careful not to overtighten the nut, as this may cause damage to the mounting surface.
9. Connect the flexible supply lines from the base of the faucet to the control handles.
10. Attach the supply lines to the water supply, hot on the left and cold on the right.
2
2
3
3 5
5
4
4
1
18
15
16
13
17
12
14
11
7
8
9
10
1
2
2
3
3 5
5
4
4
1
18
15
16
13
17
12
14
11
8
9
10
1
2
7