Blu Bathworks SB8080 - Manual (Page 9)

8
1 866 907 0122 blubathworks.com
2015-02
®
Alcove Installation using Tile Flange
In order to maintain the symmetry of these ultra-low shower base models in an alcove installation, the following points & illustration
are provided below.
1. Determine wall finish material and its thickness
2. Install tile flange on corner edge of showerbase using high density silicone above and below lip of TF.BTSB tile flange
as shown in Detail I (exploded)
3. Install shower base
4. Install wall finish
5. Apply a clear silicone bead where the shower base and wall finish meet at the flange location
**Blu Bathworks recommends TF.BTSB Tile Flange (Sold separately)
DETAIL I
Silicone
above & below lip
DETAIL I (exploded)
Instructions for use:
1. This shower base cannot be used autonomously by people with reduced motor skills, or with sensory and/or
cognitive impairments (including children), or by anyone lacking the necessary know-how needed.
2. Make sure children are supervised by a person in charge of their safety when using this shower base.
3. This shower base was designed for domestic use, or similar, and it must only be installed and used at room
temperature.
4. It is dangerous to use the shower base in the vicinity or while using electrical appliances (radios, hair dryers etc.).
5. Pay special attention when using the shower alone: standing under running hot water for a long time could cause nausea,
dizziness and lack of consciousness.
6. We do not recommend using the shower after taking medicines or any substance that could cause drowsiness or that could
affect blood pressure.
7. When the surface of the shower base is wet, the degree of slipperiness increases, especially if shampoos, soaps and oils are
used. This shower base could be slippery during its use. For this reason, you may wish to place an adhesive non-slip on it or
use a shower mat.
Do not clean using aggressive chemical agents, such as acetone, thinners, strong acids (muriatic acid etc.) or strong bases
(caustic soda etc.), nor industrial detergents or paint solvents. For more information, please refer to the cleaning & repair guide in
this document. Do not use metal scrapers, iron brushes or other domestic metal tools to remove stains, paints, plaster or other.
Some substances, such as ink, cosmetics and dyes, can stain the material if they are in contact with the surface for too long; the
same thing can happen with lit cigarettes.
We do not recommend using this product at water temperatures exceeding US / Canada maximum hot water temperature
regulations of 150°F / 65°C, respectively. The Manufacturer shall not be liable for any damages that may result from the
improper use of the product.